Wednesday, February 17, 2010

How To Interface Rf Transmitter With Pic16f877 How To Inferface RF Module With PIC16F877A?

How to inferface RF module with PIC16F877A? - how to interface rf transmitter with pic16f877

Hello, I know how to the RF transmitter and receiver with PIC16F877A interface? The RF module is a 3-pin to ground, VDD and data. The microcontroller is programmed as an adaptation to low traffic. I want to connect the sensors in the light of radio communication with the RF transceiver in touch. In the hope of receiving help and advice from someone. Thank you very much.

1 comment:

Peter H said...

If I understand correctly, you want to exit at the traffic light sensor (s) of the PIC via a wireless connection to power, rather than directly. If this is the case that the CIP must be supplied by the receiver output and the output signal of the sensor falls into the transmitter. Without knowing what the sensor output is taken, it is difficult to be accurate, but also a PIC placed between the sensor and transmitter programmed.

Post a Comment